1007 AL PolyUrea Spray
1007 AL Aliphatic PolyUrea is a two-component, 100% solids, rapid-set, high-performance polyurea spray elastomer. It is aliphatic, color-fast, and designed for exceptional physical properties, hydrolytic stability, and low permeability, while offering excellent UV stability and appearance.
Unique Properties
- Set Time: 15-20 seconds; tack-free in 60 seconds.
- Elongation: 300%-400%.
- Temperature Range: Suitable for -20°F to 200°F substrate temperatures.
- Compliance: Meets USDA standards for incidental food contact and Federal Specification A-A-59800A for Polyurea Type I & II.
Advantages
- Fully aliphatic and UV-stable.
- High elongation (400%+).
- Ideal for applications in containment, refineries, chemical plants, and marine environments.
- Protects concrete and other surfaces.
- High resistance to chemicals, impact, and abrasion.
Use Areas
- Applications requiring color stability and good appearance.
- Secondary containment with non-skid features.
- Corrosive barriers and protective coatings.
- Industrial service surfaces.
- Concrete and steel tanks.
Priming and Moisture Vapor Reduction
- Use ASTC primer PenPrime or Nova Bar 6009 epoxy for optimal results.
- Apply moisture vapor reducers (e.g., ASTC CMW) for additional protection, particularly for water features or surfaces exposed to direct sunlight.
General Physical Characteristics
Characteristic | Details |
Solids | 100% |
Shelf Life | 1 year |
Hardness (ASTM D2240) | Shore D 40 to 45 |
Mix Ratio | 1:1 |
Abrasion Resistance (ASTM D4060) | <30 CS-10 wheel/500g load, 1000 cycles |
Tensile Strength (ASTM D412) | 2100-2500 psi |
Tear Strength (ASTM D470) | 420 lbs./in. |
Elongation (ASTM D124) | 300%-400% |
VOC Content | 0 g/L |
Permeability (ASTM E96) | 0.0947 |
Static Coefficient of Friction | >0.97 |
Minimum Mil Thickness | 20 mils |
Preparation
- Ensure a minimum 28-day cure for concrete before application.
- Remove all contaminants, curing agents, and other materials that may affect bonding.
- Test for moisture vapor and ensure a rough profile (2-3 mils).
Application
- Use heated high-pressure equipment (e.g., impingement gun) at 2000 psi.
- Maintain surface temperature between -20°F and 120°F.
- Apply at least 5°F above dew point.
Limitations
- Do not apply on wet surfaces or expose part A to moisture.
- Store at room temperature on wood pallets.
- Protect from direct sunlight and extreme cold during shipping and storage.
Packaging and Curing
- Available in 110-gallon kits (two-part system with 1:1 ratio).
- VOC Content: 0 g/L.
- Curing Time: Initial access within 1-1.5 hours; full cure in 24-48 hours at 70°F.
Safety Guidelines
- For professional use only.
- Wear protective clothing and gloves; bonds strongly to fabrics.
- Refer to the MSDS before using.
- DOT Classification: Non-flammable liquid, not regulated.
Pigment Color Chart
